13 Replies Latest reply on Jun 13, 2017 9:15 AM by Carlos_A

    Requesting eepromARMtool and some questions

    HannesM Community Member


      I'm working on a custom board equipped with an ARM Cortex processor and the i210-AT ethernet controller for the network interface. Operating system is Linux (Yocto). As I understand looking to the corresponding datasheets and usage guides we need the eepromARMtool to write the configuration parameters to the iNVM. Could someone provide me with a download link of this tool?


      Further question: There are several images available to use with the EEUPDATE programming tool. From the eepromARMtool usage guide I get that these images cannot be used on ARM and the parameters must be modified within the raw byte stream to be written to the iNVM. Is this correct or is there some easier way?


      Best regards,