5 Replies Latest reply on Mar 29, 2016 1:43 PM by AdolfoS

    eDP configuration issue in Skylake-U RVP7 CRB

    DarkTiger Green Belt

      Hello

       

      I see on RVP7 CRB schematics, page 49, that CFG[4] signal is tied up to VCCIO.

      However, Skylake EDS, Vol1 on page 49 (too:)) says that "eDP port is Disabled if No Connect Pull-Down resistor on CFG[4]"

       

      Does it mean that eDP port won't work on RVP7 board?

      Is it possible to correct this by software? I have Skylake-U COM board on my table now. It does not work with eDP port, probably because of this issue.

       

      With best regards,

      Nikolay