1 Reply Latest reply on May 10, 2018 4:28 PM by Carlos_A

    Can't flash Gordon Peak MRB board

    Z.Chen Community Member

      After "r" "n" "4", the IOC console shows the following, but flashing is not started. Any suggestions are appreciated!

       

      00:00 00s362ms master_state_engine      -> wait for all modules

      00:00 00s362ms cbc_logic_core           -> startup(2 - late)

      00:00 00s363ms cbc_logic_core           -> on state

      00:00 00s367ms console_queue            -> startup(1)

      00:00 00s367ms timestamp                -> startup(1)

      00:00 00s372ms console_queue            -> on state

      00:00 00s372ms timestamp                -> on state

      00:00 00s603ms abl_control_uart         -> on state

      00:00 00s603ms Startup Counter: 1

      00:00 00s603ms System Start completed! (ABL Blob 1)

      00:00 00s603ms master_state_engine      -> on state

      00:00 00s603ms ------------------------------------------------------

      00:00 00s603ms ACTIVE stay alive Reasons:

      00:00 00s603ms  wakeup button (trigger)

      00:00 00s603ms UART reset performed

      00:00 00s755ms UART reset performed

      00:00 02s890ms Terminal command: n Do start system (1 = Normal, 2 = Recovery, 3 = Download, 4 = Emergency, 0 = Shell): Input: 4

      00:00 02s890ms Wakeup button state (emergency boot)

      00:00 02s890ms DNX disabled

      00:00 02s890ms Set boot selector for(once) to ID 0x4

      00:00 02s890ms Boot Selector: using once entry

      00:00 09s852ms Changed HW flow control setting for UART 5 to 1

      00:02 10s187ms  Temp. (id 0) = 33 C; Temp. (id 1) = 31 C; Supply: 12.27 V atc = 2; FAN 99 rpm; FAN 15 %